Cisco Cisco XR 12000 12000 1-Port OC-48c STM-16c POS SDH ISE Line Card
42
Packet-Over-SONET Line Card Installation and Configuration
78-16412-02
Line Card Cable-Management Bracket
Figure 35
Installing a Slide Tab SFP Module
Note
Verify that the SFP modules are completely seated and secured in their assigned receptacles on the line
card by firmly pushing on each SFP module. If the SFP module was not completely seated and secured
in the receptacle, you will hear a click as the triangular pin on the bottom of the SFP module snaps into
the hole in the receptacle.
card by firmly pushing on each SFP module. If the SFP module was not completely seated and secured
in the receptacle, you will hear a click as the triangular pin on the bottom of the SFP module snaps into
the hole in the receptacle.
Line Card Cable-Management Bracket
Note
The illustrations in this section show various line cards, but the line card cable-management bracket
installation procedure is the same regardless of the specific line card.
installation procedure is the same regardless of the specific line card.
Cisco 12000 Series Routers include a cable-management system that organizes the interface cables
entering and exiting the router, keeping them out of the way and free of sharp bends.
entering and exiting the router, keeping them out of the way and free of sharp bends.
Caution
Excessive bending of interface cables can damage the cables.
The cable-management system consists of two separate components:
1.
A cable-management tray that is mounted on the chassis. Refer to the appropriate Cisco 12000
Series Router installation and configuration guide for more information on the cable-management
tray.
Series Router installation and configuration guide for more information on the cable-management
tray.
ACTIVE
CARRIER
RX PACKET
ACTIVE
CARRIER
RX PACKET
WRAP
PASS THRU
2
WRAP
PASS THRU
3
4OC48/SRP-SFP
84649