Cisco Cisco XR 12000 12000 1-Port OC-48c STM-16c POS SDH ISE Line Card
77
Packet-Over-SONET Line Card Installation and Configuration
78-16412-02
Line Card Memory
While the diagnostic test is running, the line card does not function normally and cannot pass any traffic
for the duration of the testing. Without the verbose keyword, the command provides a truncated output
message. When communicating with the Cisco TAC, the verbose mode is helpful in identifying specific
problems. The output of the diagnostic test without the verbose command appears like the following
example:
for the duration of the testing. Without the verbose keyword, the command provides a truncated output
message. When communicating with the Cisco TAC, the verbose mode is helpful in identifying specific
problems. The output of the diagnostic test without the verbose command appears like the following
example:
Router#diag 3
Running DIAG config check
Running Diags will halt ALL activity on the requested slot
[confirm]
Router#
Launching a Field Diagnostic for slot 3
Downloading diagnostic tests to slot 3 (timeout set to 600 sec.)
*Nov 18 22:20:40.237: %LINK.5.CHANGED: Interface GigabitEthernet3/0,
changed state to administratively down
Field Diag download COMPLETE for slot 3
FD 3> *****************************************************
FD 3> GSR Field Diagnostics V4.0
FD 3> Compiled by award on Thu May 18 13:43:04 PDT 2000
FD 3> view: award.conn_isp.FieldDiagRelease
FD 3> *****************************************************
FD 3> BFR_CARD_TYPE_1P_GE testing...
FD 3> running in slot 3 (83 tests)
Executing all diagnostic tests in slot 3
(total/indiv. timeout set to 600/200 sec.)
Field Diagnostic: ****TEST FAILURE**** slot 3: last test run 51,
Fabric Packet Loopback, error 3
Shutting down diags in slot 3
slot 3 done, will not reload automatically
The line card reloads automatically only after passing the test. In the example above, the line card failed
the test and did not reload automatically. You can manually reload the line card by using the hw-module
slot slot reload command.
the test and did not reload automatically. You can manually reload the line card by using the hw-module
slot slot reload command.
Field diagnostic results are stored in an EEPROM on the line card. It is possible to view the results of
the last diagnostic test performed on the line card by executing the diag slot previous command.
the last diagnostic test performed on the line card by executing the diag slot previous command.
There are some caveats that exist that cause diagnostic tests to fail, even though the line card is not faulty.
As a precaution, if the line card fails and had been replaced previously, you should review this output
with the Cisco TAC.
As a precaution, if the line card fails and had been replaced previously, you should review this output
with the Cisco TAC.
Line Card Memory
This section contains information about the following:
•
•
You can replace the route memory on POS line cards. Route memory modules are installed into 144-pin
small-outline DIMM (SODIMM) sockets. Route memory runs the Cisco IOS software image and stores
the updated network routing tables downloaded from the route processor.
small-outline DIMM (SODIMM) sockets. Route memory runs the Cisco IOS software image and stores
the updated network routing tables downloaded from the route processor.
provides information about the various hardware engines available with the POS line cards. The
engine determines where the memory is placed.