Cisco Cisco UCS B200 M2 Blade Server Hoja De Datos
Cisco UCS B460 M4 Blade Server (with Intel® Xeon E7 v2 CPU)
46
SUPPLEMENTAL MATERIAL
http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/hw/blade-servers/B460M4.html
CPU Removal and Installation (“pick n place”) Tool Set
The Pick n Place tool set is used to install a CPU in its socket without damage. It must be used each time a
CPU is installed in the server.
CPU is installed in the server.
Instructions for using this tool set are found at the following link:
http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/hw/blade-servers/B460M4.html
Thermal Grease (with syringe applicator) for CPU to Heatsink Seal
Thermal grease must be applied to the top of the CPU where it comes in contact with the heat sink.
Instructions for applying thermal grease are found at:
Instructions for applying thermal grease are found at:
http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/hw/blade-servers/B460M4.html
NOTE: When you purchase a spare CPU, the Pick n Place Toolkit is included.
CAUTION:
DO NOT use thermal grease available for purchase at any commercial
electronics store. If these instructions are not followed, the CPU may
overheat and be destroyed.
electronics store. If these instructions are not followed, the CPU may
overheat and be destroyed.
NOTE: When you purchase a spare CPU, the thermal grease with syringe applicator
is included.
is included.