Cisco Cisco CWDM Single Fiber MUX 4 Mux Demux Module Guía De Instalación
7
Installation Note for the CWDM Passive Optical System
78-14167-01
Hardware Requirements
Warning
Before you install, operate, or service the system, read the Site Preparation and Safety
Guide. This guide contains important safety information you should know before
working with the system.
Guide. This guide contains important safety information you should know before
working with the system.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service
this equipment.
this equipment.
Warning
Class 1 laser product.
Warning
Because invisible laser radiation may be emitted from the aperture of the port when no
cable is connected, avoid exposure to laser radiation and do not stare into open
apertures.
cable is connected, avoid exposure to laser radiation and do not stare into open
apertures.
Warning
Ultimate disposal of this product should be handled according to all national laws and
regulations.
regulations.
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do
not directly touch the backplane with your hand or any metal tool, or you could shock
yourself.
not directly touch the backplane with your hand or any metal tool, or you could shock
yourself.
Hardware Requirements
You can use the CWDM passive optical system with Catalyst 4000 and 6000 family switches. Use
single-mode fiber-optic cable with SC connectors to connect the CWDM passive optical system to your
switches.
single-mode fiber-optic cable with SC connectors to connect the CWDM passive optical system to your
switches.
Required Tools
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do
not directly touch the backplane with your hand or any metal tool, or you could shock
yourself.
not directly touch the backplane with your hand or any metal tool, or you could shock
yourself.
You will need these tools to install the CWDM passive optical system:
•
Wrist strap or other grounding device
•
Antistatic mat or antistatic foam
•
Number 1 and number 2 Phillips screwdrivers for the captive installation screws on most modules
•
3/16-inch flat-blade screwdriver for captive installation screws