Cisco Cisco Unified Customer Voice Portal 10.0(1)

This entry matches the ringtone.tcl dial peer in the gateway configuration. It provides the
sound of the ringing phone after you dial the exercise test number.

•

92> and 10.86.132.177 (ingress gateway's IP address)

This entry matches the cvperror.tcl dial peer in the gateway configuration. It provides error
handling.

•

123456789> and 10.86.132.177 (ingress gateway's IP address)

This entry will match the VRU label you establish later in ICM. It is used to pass incoming
calls to ICM. The ">" indicates any additional digits after the "123456789" and is added
because additional digits are added to the label by ICM.

•

40> and 10.86.132.142 (Unified Communications Manager)

This entry identifies a set of phones that the CVP Unified Communications Manager can
send the exercise test call to. In this test setup, we send the call to a phone with an extension
beginning with 40. The 40> entry will match any phone number that begins with 40. The IP
address should be the Unified CM server you are using for this exercise. If you will be sending
the call to a different phone number, use that number instead of 40>.

Figure 62: CVP Call Server - Configure for Comprehensive Exercise

Click Save &Deploy to accept the default values for the items in the other tabs, save the
configuration, and deploy the call server to the CVP example installation. (You will receive a
message that certain fields have changed. Click OK to continue.)

You should see a "successfully added to the network map" message, similar to the following.

Figure 63: CVP Operations Console - Call Server Successfully Added

Leave the Operations Console open for the next task.

Getting Started with Cisco Unified Customer Voice Portal Release 8.0(0)