Cisco Cisco MediaSense Release 8.5(1) Guía De Instalación
Installing the Unified MCP Software
To install the Unified MCP application and the Unified OS, follow this procedure.
Note:
At any time during the installation process, you can click Help to get further information
about that particular screen.
Caution: The installation process is different for the primary server and for all other
servers in a deployment. Once you have identified and assigned your primary and secondary
servers, you will not be able to change the assignment. Be sure to carefully identify these
two servers before you install or configure them.
servers in a deployment. Once you have identified and assigned your primary and secondary
servers, you will not be able to change the assignment. Be sure to carefully identify these
two servers before you install or configure them.
Verify that you have already addressed all VM requirements listed in the
( http://cisco.com/go/uc-virtualized) website.
Step 1
Insert the Unified MCP installation disc into the DVD tray and restart the server, so it boots
from the DVD. After the server completes the boot sequence, the DVD Found window displays.
Step 2
To perform the media check, select Yes. To skip the media check, select No.
The media check verifies the integrity of the installation disc. If your disc passed the media
check previously, you may choose to skip this step.
a.
If you choose to perform the media check, the Media Check Result window displays with
the progress bar for the media check.
Note:
Depending on your server setup, the media check can take approximately five minutes
to complete.
b.
If:
If the Media Check Result displays PASS,
Then:
click OK to continue the installation.
If:
If the media check fails,
Then:
eject the DVD to terminate the installation.
At this point you have several choices depending on your service-level agreement:
•
Download another copy from Cisco.com (CDC)
•
Obtain another installation disc directly from Cisco
•
Contact your service provider for assistance
Step 3
The system installer performs the following hardware checks to ensure that your system is
correctly configured. If the installer makes any changes to your hardware configuration settings,
you will get prompted to restart your system.
Installation and Administration Guide for Cisco MediaSense 8.5(1)
13
Chapter 2: Installing Unified MCP
Installing the Software