Cisco Cisco Aironet 1310 Access Point Bridge Guía De Instalación
39
Cisco Aironet 1300 Series Wireless Bridge Mounting Instructions
78-16136-02B0
Activating the Bridge Link
ENGLISH
Step 3
If the Install LED starts blinking green, the non-root bridge failed to associate with the root bridge.
Power cycle the bridge, wait for the Install LED to blink amber, and then slowly pan the antenna left to
right or tilt it up and down until the Install LED changes to continuous amber. In the default
configuration, you have only 60 seconds to achieve association.
Power cycle the bridge, wait for the Install LED to blink amber, and then slowly pan the antenna left to
right or tilt it up and down until the Install LED changes to continuous amber. In the default
configuration, you have only 60 seconds to achieve association.
Step 4
Align the antenna using the LED indications. For more information, see the
.
Enabling the Radio Interface
After you obtain the bridge IP address, follow these instructions to enable the radio interface:
Step 1
Use your web-browser to access your bridge.
Step 2
When the Summary Status page displays, click Network Interfaces > Radio0-802.11g and the radio
status page displays.
status page displays.
Step 3
Click Settings and the radio settings page displays.
Step 4
Click Enable in the Enable Radio field.
Step 5
Click Apply.
Step 6
Close your web-browser.
Changing Radio Role and SSID Settings
After you obtain the bridge IP address, you can browse to its Express Setup page and perform an initial
configuration. Follow these steps:
configuration. Follow these steps:
Step 1
Browse to the bridge IP address. An Enter Network Password window displays.
Step 2
Enter the case-sensitive username Cisco in the Username field.
Enter the case-sensitive password Cisco in the Password field and press Enter. The Summary Status
page displays, which is the bridge home page.
page displays, which is the bridge home page.
Step 3
Click Express Setup. The Express Setup page displays.
Step 4
In the Role in Radio Network field, click the check box that describes the needed role for the bridge on
your network.
your network.
Note
In Cisco IOS Release 12.3(2)JA2 or earlier, the bridge is default configured in bridge install
mode with automatic bridge detection activated. In Cisco IOS Release 12.3(4)JA, the bridge is
default configured in root access point mode.
mode with automatic bridge detection activated. In Cisco IOS Release 12.3(4)JA, the bridge is
default configured in root access point mode.
•
Install Mode—Activates the bridge install and alignment mode. Specifies that the bridge
automatically determines the network role. If the bridge is able to associate to another Cisco Aironet
root bridge within 60 seconds, the bridge assumes a non-root bridge role. If unable to associate with
another Cisco Aironet root bridge within 60 seconds, the bridge assumes a root bridge role.
automatically determines the network role. If the bridge is able to associate to another Cisco Aironet
root bridge within 60 seconds, the bridge assumes a non-root bridge role. If unable to associate with
another Cisco Aironet root bridge within 60 seconds, the bridge assumes a root bridge role.