Cisco Cisco Firepower Management Center 2000 Notas de publicación
Firepower System Release Notes
Installing the Update
Installing the Update on Clustered Devices
When you install an update on clustered devices (in Version 6.0, 7000 Series or 8000 Series devices or device stacks in
a high-availability pair), the system performs the update on the devices one at a time. When the update starts, the system
applies the update one device at a time.
a high-availability pair), the system performs the update on the devices one at a time. When the update starts, the system
applies the update one device at a time.
Installing the Update on Stacked Devices
When you install an update on stacked devices, the system performs the updates simultaneously. Each device resumes
normal operation when the update completes. Note that:
normal operation when the update completes. Note that:
If the primary device completes the update before all of the secondary devices, the stack operates in a limited,
mixed-version state until all devices have completed the update.
mixed-version state until all devices have completed the update.
If the primary device completes the update after all of the secondary devices, the stack resumes normal operation
when the update completes on the primary device.
when the update completes on the primary device.
After the Installation
After you perform the update on either the Firepower Management Center or managed devices, you must redeploy
your configurations. Deployment may cause a short pause in traffic flow and processing, and may also cause a few
packets to pass uninspected. For more information, see the Firepower Management Center Configuration Guide.
your configurations. Deployment may cause a short pause in traffic flow and processing, and may also cause a few
packets to pass uninspected. For more information, see the Firepower Management Center Configuration Guide.
There are several additional post-update steps you should take to ensure that your appliances are performing properly.
These include:
These include:
verifying that the update succeeded
making sure that all appliances in your deployment are communicating successfully
updating to the latest patch for Version 6.0, if available, to take advantage of the latest enhancements and security
fixes
fixes
optionally, updating your intrusion rules and vulnerability database (VDB) and redeploying your configurations
The next sections include detailed instructions not only on performing the update, but also on completing any
post-update steps. Make sure you complete all of the listed tasks.
post-update steps. Make sure you complete all of the listed tasks.
Updating Firepower Management Centers
Caution:
You
must
install the FireSIGHT System Version 6.0.0 Pre-Installation package prior to updating the Version
6.0. For more information, see the
.
Use the procedure in this section to update your Firepower Management Centers, including virtual Firepower
Management Centers. For the Version 6.0 update, Firepower Management Centers reboot.
Management Centers. For the Version 6.0 update, Firepower Management Centers reboot.
Caution:
Before you update the Firepower Management Center, redeploy your configurations to any managed
devices. Otherwise, the managed device update may fail.
Caution:
Do not reboot or shut down your appliances during the update until after you see the login prompt. The
system may appear inactive during the pre-checks portion of the update; this is expected behavior and does not
require you to reboot or shut down your appliances.
require you to reboot or shut down your appliances.
Note:
Updating a Firepower Management Center to Version 6.0 removes existing uninstallers from the appliance.
To update a Firepower Management Center:
Step 1
Read these release notes and complete any required pre-update tasks.
Note:
If the Firepower Management Center is running Version 5.4.1.1, Version 5.4.1.2, Version 5.4.1.3, Version 5.4.1.4,
or Version 5.4.1.5 prior to updating to Version 6.0, you must install the Version 6.0 Pre-Installation Package prior to
updating to Version 6.0. For more information, see
updating to Version 6.0. For more information, see