Cisco Cisco Content Security Management Appliance M160 Guía De Instalación

Access the command-line interface locally or remotely:

To access the CLI locally, set up a terminal to 
connect to the serial port using 9600 bits, 8 bits, no 
parity, 1 stop bit (9600, 8, N, 1) and flow control 
set to Hardware. To physically connect the 
terminal, see the 

To access the CLI remotely, initiate an SSH session 
to the IP address 192.168.42.42.

Log in as admin with the password ironport. 

At the prompt, run the systemsetup command.

Run the System Setup Wizard to configure basic settings and 
enable a set of system defaults. The System Setup Wizard starts 
automatically when you access the appliance via the web-based 
interface (or when you run the systemsetup command from the 
command-line interface.) 

Accept the end user license agreement.

Enter system and network information from the 

If you need additional information about the settings, 
choose Help and Support > Online Help. 

Review the configuration summary page. 

Click Install this Configuration. 

The appliance may not appear to have accepted your 
configuration or be performing the installation. This is 
because you have changed the IP address, but the 
installation is underway. 

M390_QSG.fm  Page 9  Thursday, March 24, 2016  11:25 AM