Cisco Cisco Content Security Management Appliance M160 Guía Del Usuario
14-14
AsyncOS 8.1 for Cisco Content Security Management User Guide
Chapter 14 Common Administrative Tasks
Figure 14-2
Disaster Recovery: Final Result
Upgrading Appliance Hardware
If you are upgrading from an older Security Management appliance to a newer model, perform the
following steps to transfer the data from the older appliance to the new appliance successfully.
following steps to transfer the data from the older appliance to the new appliance successfully.
Note
It is important to remember that while it is possible to transfer data between Security Management
appliances that are different sizes, the new appliance must have the same size allocations or greater.
appliances that are different sizes, the new appliance must have the same size allocations or greater.
Figure 14-3
Upgrading to a New Security Management Appliance Hardware
Before You Begin
•
Understand the information in
.
•
Meet the prerequisites described in
•
Save a copy of the configuration file from your source appliance to a location that you can reach
from the target appliance. See
from the target appliance. See
.
•
You may need to edit the configuration file before importing it into the new appliance. For example,
change interface IP addresses to ensure that they are unique on the network, or make the interface
names on the new appliance match the corresponding interface names on the old appliance.
change interface IP addresses to ensure that they are unique on the network, or make the interface
names on the new appliance match the corresponding interface names on the old appliance.
SMA 1
data
SMA 2
ESA 2
ESA 1
WSA 1
ESA 3
M160
(source)
M650
(target)
data