Cisco Cisco IOS Software Release 12.0(14)S
PA-MC-2T3+ Phase-II (T3 subrate)
Command Reference
12
12.0(14)S
Configuring a Subrate T3 Interface
In order to configure a subrate T3 interface, you must first configure the interface as a full-rate T3 using
the no channelized configuration controller command. After the full-rate T3 interface is configured,
use the dsu bandwidth command to create a subrate T3 interface.The following example configures a
subrate T3 interface on a Cisco 7200 series router:
the no channelized configuration controller command. After the full-rate T3 interface is configured,
use the dsu bandwidth command to create a subrate T3 interface.The following example configures a
subrate T3 interface on a Cisco 7200 series router:
Router(config)# controller t3 2/0
Router(config-controller# no channelized
Router(config-controller)# exit
Router(config)# interface serial 2/0
Router(config-if)# dsu bandwidth 16000
Router(config-if)# encapsulation frame-relay
Router(config-if)# ip address 10.10.10.10 255.255.255.255
Router(config-if)# no shutdown
Command Reference
This section documents the new command that configures the clear channel T3 subrate feature.