Cisco Cisco MDS 9000 SAN-OS Software Release 1.0 Notas de publicación
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
10
Cisco MDS 9000 Family Release Notes for Storage Services Interface Image Release 5.0(4j)
OL-22148-05
Related Documentation
Resolved Caveats
•
CSCtg23573
Symptom: A critical error such as a DPP failure on a service module running SANTap may result
in a module or switch reload. The reload may take an extra 10 minutes on a Cisco MDS MSM-18/4
module or a MDS 9222i supervisor module that is running SANTap.
in a module or switch reload. The reload may take an extra 10 minutes on a Cisco MDS MSM-18/4
module or a MDS 9222i supervisor module that is running SANTap.
Conditions: This symptom may be seen only when SANTap is running on the Cisco MDS
MSM-18/4 module or on a Cisco MDS 9222i supervisor module.
MSM-18/4 module or on a Cisco MDS 9222i supervisor module.
Workaround: This issue is resolved.
Open Caveats
•
CSCti56186
Symptom: Following a successful upgrade of the SSI image on a Cisco MDS MSM-18/4 module
where SANTap is enabled, SANTap may go into an unknown state.
where SANTap is enabled, SANTap may go into an unknown state.
Workaround: After the upgrade is completely finished, manually reload the Cisco MDS MSM-18/4
module to recover from the unknown state.
module to recover from the unknown state.
•
CSCti60854
Symptom: When you enter the system default switchport shutdown command, all iSAPI ports go
down.
down.
Workaround: None.
•
CSCtj37367
Symptom: If SANTap is configured on multiple modules on a switch and one of the modules is not
provisioned, the SANTap Prevent Downgrade Capability is removed for the entire setup.
provisioned, the SANTap Prevent Downgrade Capability is removed for the entire setup.
This symptom might be seen when more than one module in the switch is configured with SANTap
and the configuration is removed from one of these modules. SANTap does not check for the
presence of other modules before removing the capability.
and the configuration is removed from one of these modules. SANTap does not check for the
presence of other modules before removing the capability.
Workaround: None.
•
CSCtk60509
Symptom: The SANTap DPP may cause CRC errors in a multiple a FE/BE VSAN setup with a
heavy I/O load.
heavy I/O load.
Conditions: This symptom might be seen when SANTap is running on a Cisco MDS MSM-18/4
module or Cisco MDS 9222i module with a multiple FE/BE VSAN configuration, and there is a
heavy I/O load on both VSANs.
module or Cisco MDS 9222i module with a multiple FE/BE VSAN configuration, and there is a
heavy I/O load on both VSANs.
Workaround: None.
Related Documentation
The documentation set for NX-OS for the Cisco MDS 9000 Family includes the following documents.
To find a document online, access the following web site:
To find a document online, access the following web site: