Cisco Cisco MDS 9000 NX-OS Software Release 5.2 Notas de publicación
41
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 5.2(8)
OL-27554-04
Caveats
Resolved Caveats
•
CSCtx92067
Symptoms: The SANTap DDP process failed and the following messages appeared:
%PORT-5-IF_DOWN_SOFTWARE_FAILURE: %$VSAN 4094%$ Interface isapi4/1/1 is down (Port
software failure)
%PORT-5-IF_DOWN_SOFTWARE_FAILURE: %$VSAN 4094%$ Interface isapi4/1/2 is down (Port
software failure)
%PORT-5-IF_DOWN_SOFTWARE_FAILURE: %$VSAN 4094%$ Interface isapi4/1/3 is down (Port
software failure)
%PORT-5-IF_DOWN_SOFTWARE_FAILURE: %$VSAN 4094%$ Interface isapi4/1/4 is down (Port
software failure)
%SANTAP-SLOT4-2-ISAPI_CRIT_PROCESS_CRASH: DPP status: ISAPI_DPP_CONNECT_STATUS_NOT_OK.
SANTAP aborting. SANTAP VM Size: 22816kB
%RM-SLOT4-2-RM_VICPP_RECREATE_ERROR: All the fast path resources are down VICPP
connectivity lost
%PROC_MGR-SLOT4-2-ERR_MSG: ERROR: PID 1495 (ps_stap) killed with signal (6)
%RM-SLOT4-2-CPP_CATASTROPHIC_ERROR: ERROR: Component (Partner Software) caused
critical error. Service Module will be reloaded
%IPS_SB_MGR-SLOT4-2-PORT_SOFTWARE_FAILURE: Port software failure, module 4 port 1
%IPS_SB_MGR-SLOT4-2-PORT_SOFTWARE_FAILURE: Port software failure, module 4 port 2
%IPS_SB_MGR-SLOT4-2-PORT_SOFTWARE_FAILURE: Port software failure, module 4 port 3
%IPS_SB_MGR-SLOT4-2-PORT_SOFTWARE_FAILURE: Port software failure, module 4 port 4
%MODULE-2-MOD_DIAG_FAIL: Module 4 (serial: JAF1504BMNN) reported failure on ports
4/1-4/22 (0x0) due to ISAPI experienced an error in device 41 (device error 0x0)
Workaround: This issue is resolved.
•
CSCty59570
Symptom: After replacing a smart card that reached the maximum number of shares (16), the new
smart card gets stuck in the initializing state.
smart card gets stuck in the initializing state.
Workaround: This issue is resolved.
•
CSCty68838
Symptom: Periodic FCIP port flaps might occur when Tape Acceleration and IP compression are
enabled and the MTU is configured at 9000. This situation might lead to a failure or an IPS core.
enabled and the MTU is configured at 9000. This situation might lead to a failure or an IPS core.
This symptom might be seen when the following configuration is applied to an FCIP tunnel:
–
Tape Acceleration (TA) is enabled.
–
Write Acceleration (required for TA) is enabled.
–
IP compression in enabled.
–
The MTU size is 9000.
Workaround: This issue is resolved.
O
R
O
O
Table 17
Open Caveats and Resolved Caveats Reference (continued)
DDTS Number
NX-OS Software Release (Open
or Resolved)
or Resolved)
NX-OS Software Release (Open
or Resolved)
or Resolved)
5.2(6b)
5.2(8)