Cisco Cisco IOS Software Releases 12.2 MC Notas de publicación

One or more PPP multilink interfaces with PPP mux and RTP header compression attributes.

A virtual template for each of the multilink groups.

A PVC under the switch subinterface that references the virtual template.

In addition, you must configure a connection between the PVC and the FRSM as well as a connection 
between the FRSM and the PVC.

For detailed information about the MGX-RPM-1FE-CP back card and its implementation in the IP-RAN 
solution, see the MGX-RPM-1FE-CP Back Card Installation and Configuration Note.

The MGX-RPM-1FE-CP requires the following system configuration:

Cisco IOS 12.2(8) MC1 or a later Cisco IOS Release 12.2 MC image is installed on the 
corresponding Cisco MGX 8850 RPM-PR.

The FE interface is configured via the Cisco IOS software command line interface.

To determine the version of Cisco IOS software copied on the RPM-PR, access the CLI of the RPM-PR 
and enter the show version command:

rpm> show version

     Cisco Internetwork Operating System Software 

     IOS (tm) RPM Software (RPM-JS-M), Version 12.2(15)MC2a, EARLY DEPLOYMENT RELEASE 

     SOFTWARE (fc1)

For information about copying Cisco IOS images to RPM-PR Flash memory, see the RPM-PR 
Installation and Configuration document.

For general information about upgrading to a new Cisco IOS software release, refer to Software 
Installation and Upgrade Procedures located at the following URL:

The following sections list the new hardware and software features supported by the 
Cisco MGX-RPM-1FE-CP for Cisco IOS Release 12.2(15)MC software.

No features are introduced in Cisco IOS Release 12.2(15)MC2f.