Cisco Cisco IOS Software Releases 12.2 B Guía Del Usuario

The default trap level is informational. The no logging trap command disables logging to the syslog 
servers. The show logging command displays the addresses and levels associated with the current 
logging setup.

Reference the IOS documentation for additional information about message logging and setting up 
Syslog servers.

The following PDSN debug commands are allowed on PDSN R1.2 routers. These debugs are described 
in detail in the Command Reference section of this document. This section describes how to enable 
conditional debugging for the corresponding command.

An asterisk (*) denotes that you can use this command with conditional debugging.

CDMA PDSN a10 *

CDMA PDSN a11 *

CDMA PDSN Accounting *

CDMA PDSN Clustering (only c6 images)

CDMA PDSN Prepaid (only c6 images)

CDMA PDSN Resource Manager

CDMA PDSN Selection

CDMA PDSN Service-Selection*

CDMA PDSN Session-Related Information *

The prepaid and cluster debugs are only available with c6 images, and will not work for the c5 images.

The following debugs help monitor the a10 data information:

7206-PDSN#deb cdma pdsn a10 ?

ahdlc—CDMA PDSN a10 ahdlc *

gre—CDMA PDSN a10 gre *

ppp—CDMA PDSN a10 ppp *

The following debugs help monitor the a10 ahdlc data information.

7206-PDSN#debug cdma pdsn a10 ahdlc ?

errors—CDMA PDSN a10 ahdlc errors *

events—CDMA PDSN a10 ahdlc events *

packet—CDMA PDSN a10 ahdlc packet *