Cisco Cisco IOS Software Release 12.4(23) Notas de publicación
533
Caveats for Cisco IOS Release 12.4
OL-7656-15 Rev. J0
Resolved Caveats—Cisco IOS Release 12.4(8)
Conditions: This symptom is observed on a Cisco platform that functions as an AP and that runs
Cisco IOS Release 12.3(2)JA2 or Release 12.3(4)JA when EAP-TLS is configured. The symptom
may also occur in other releases.
Cisco IOS Release 12.3(2)JA2 or Release 12.3(4)JA when EAP-TLS is configured. The symptom
may also occur in other releases.
Workaround: Issue a new client certificate.
•
CSCei05246
Symptoms: After an OIR of a PA-MC-E3 port adaptor that is installed in a VIP6-80, the serial
interfaces do not transmit. The message “not transmitting” is generated, followed by “output
frozen.” After these messages, a Cbus Complex occurs.
interfaces do not transmit. The message “not transmitting” is generated, followed by “output
frozen.” After these messages, a Cbus Complex occurs.
Conditions: This symptom is observed on a Cisco 7500 series.
Workaround: There is no workaround.
•
CSCei49231
Symptoms: A router may crash when a large number of calls passes through an E1 CAS link.
Conditions: This symptom is observed on a Cisco 3800 series that has an E1 CAS link that is
configured for E&M wink start signaling.
configured for E&M wink start signaling.
Workaround: There is no workaround.
•
CSCei86389
Symptoms: You cannot change the user locale to the RU or NL language.
Condition: This symptom is observed on a Cisco 7960 IP phone.
Workaround: There is no workaround. If this is an option for you, use the default user locale, which
is the US language.
is the US language.
•
CSCej11073
Symptoms: An attempt to re-enable SSG fails after you have entered the no ssg enable
force-cleanup command because the SSG unconfiguration process enters an infinite loop.
force-cleanup command because the SSG unconfiguration process enters an infinite loop.
Conditions: This symptom is observed on a Cisco router that has about 4000 live sessions.
Workaround: There is no workaround.
•
CSCej27978
Symptoms: A CE router that is configured for VRFLite does not receive Auto-RP mappings.
Conditions: This symptom is observed when MDS is enabled on the multilink interface that connects
the CE router and the PE router.
the CE router and the PE router.
Workaround: Configure process switching on the multilink interface that connects the CE router and
the PE router by entering the no ip mroute-cache interface configuration command.
the PE router by entering the no ip mroute-cache interface configuration command.
•
CSCej87817
Symptoms: Policing does not drop any packets after the packets are sent or received at a rate that is
much higher than the committed information rate (CIR).
much higher than the committed information rate (CIR).
Conditions: This symptom is observed on a Cisco 7500 series router but is not platform dependent.
Workaround: There is no workaround.
•
CSCek24468
Symptoms: Dangling bearer channels or voice DSP channels may occur.
Conditions: This symptom is observed under heavy stress with short duration calls on a
Cisco platform such as a Cisco AS5400 or Cisco AS5850 that functions as a gateway.
Cisco platform such as a Cisco AS5400 or Cisco AS5850 that functions as a gateway.
Workaround: There are no workaround.