Cisco Cisco IOS Software Release 12.4(23) Notas de publicación
![Cisco](https://files.manualsbrain.com/attachments/7380d0050044647c30f5c24bbbf5d0c0b6d9bb84/common/fit/150/50/faa183d287233c52228cfea3dbc2a127fe780f60564fcb0955d9c3d1cd23/brand_logo.png)
904
Caveats for Cisco IOS Release 12.4
OL-7656-15 Rev. J0
Resolved Caveats—Cisco IOS Release 12.4(1b)
show memory debug leaks show memory debug leaks chunks show memory debug leaks
largest show memory debug leaks summary
largest show memory debug leaks summary
Conditions: This symptom has been observed on the RPM-XF cards using Cisco IOS interim
Release 12.4(4.6).
Release 12.4(4.6).
Workaround: There is no workaround.
Wide-Area Networking
•
CSCei11919
Symptoms: A dialed circuit that carries a PPP connection over a tunnel between an LNS and a LAC
is not dropped when the tunnel is reset.
is not dropped when the tunnel is reset.
Conditions: This symptom is observed when you enter the clear vpdn all command, when the LNS
reloads, when the IP link between the LSN and LAC is disrupted, or when any other event occurs
that causes the tunnel to be reset.
reloads, when the IP link between the LSN and LAC is disrupted, or when any other event occurs
that causes the tunnel to be reset.
Workaround: There is no workaround.
•
CSCej45061
Symptoms: Attempts to remove a PRI group fail.
Conditions: This symptom is observed when an NFAS group has group number 0 and when you
attempt to remove a FAS PRI group.
attempt to remove a FAS PRI group.
Workaround: Shut down the NFAS group before you remove the FAS PRI group.
•
CSCsa55747
Symptoms: The RADIUS L2TP-specific disconnect code value for the Ascend-Disconnect-Cause
RADIUS attribute (195) is incorrectly generated as 607 instead of 605.
RADIUS attribute (195) is incorrectly generated as 607 instead of 605.
Conditions: This symptom is observed when an L2TP tunnel setup failure occurs between a LAC
and an LNS.
and an LNS.
Workaround: There is no workaround.
•
CSCsa66756
Symptoms: The B channel on an NFAS "none" group member may hang with its channel state set
to PROPOSED, which you can see in the output of the show isdn service command.
to PROPOSED, which you can see in the output of the show isdn service command.
Conditions: This symptom is observed when the first activity on an NFAS "none" member is an
outgoing call. After the first incoming or outgoing call, the symptom does no longer occur.
outgoing call. After the first incoming or outgoing call, the symptom does no longer occur.
Workaround: There is no workaround.
Resolved Caveats—Cisco IOS Release 12.4(1b)
Cisco IOS Release 12.4(1b) is a rebuild release for Cisco IOS Release 12.4(1). The caveats in this
section are resolved in Cisco IOS Release 12.4(1b) but may be open in previous Cisco IOS releases.
section are resolved in Cisco IOS Release 12.4(1b) but may be open in previous Cisco IOS releases.