Cisco Cisco IOS Software Release 12.2(35)SE Notas de publicación
21
Release Notes for the Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell, Cisco IOS Release 12.2(40)EX1
OL-13273-01
Documentation Updates
•
CSCsk19926
Traffic is not received on a member port in a switch stack under these conditions:
–
The port is in a cross-stack EtherChannel.
–
One or more of the master switch Cisco TwinGig Converter Module ports are in the cross-stack
EtherChannel.
EtherChannel.
–
This member switch has been reloaded.
The workaround is to enter the shutdown and no shutdown interface configuration commands on
the affected interface, or to reload the entire stack instead of a single member switch.
the affected interface, or to reload the entire stack instead of a single member switch.
•
CSCsl49153
You might receive a traceback message when you use the no interface port-channel global
configuration command to delete interfaces from an EtherChannel that has port channels on multiple
stack members.
configuration command to delete interfaces from an EtherChannel that has port channels on multiple
stack members.
The workaround is to save the configuration and to reload the stack.
•
CSCsl63862
When you use the switch renumber global configuration command to renumber a member switch
in a switch stack and then reload the switch, the internal server-facing ports do not have the required
default of spanning-tree portfast enabled.
in a switch stack and then reload the switch, the internal server-facing ports do not have the required
default of spanning-tree portfast enabled.
The workaround is to apply the switch provision configuration before you reboot the switch.
Enter both the switch current-stack-member-number renumber new-stack-member-number and the
switch stack-member-number provision type global configuration commands, and reload the
switch.
Enter both the switch current-stack-member-number renumber new-stack-member-number and the
switch stack-member-number provision type global configuration commands, and reload the
switch.
Documentation Updates
This update is for the software configuration guide:
If the switch is running the IP base image, you can configure complete EIGRP routing. However, the
configuration is not implemented because the IP base image supports only EIGRP stub routing, as
described in the "Configuring IP Unicast Routing" chapter of the software configuration guide.
configuration is not implemented because the IP base image supports only EIGRP stub routing, as
described in the "Configuring IP Unicast Routing" chapter of the software configuration guide.
After you have entered the eigrp stub router configuration command, only the eigrp stub connected
summary command takes effect. Although the CLI help might show the receive-only and static
keywords and the you can enter these keywords, the switch running the IP base image always behaves
as if the connected and summary keywords were configured.
summary command takes effect. Although the CLI help might show the receive-only and static
keywords and the you can enter these keywords, the switch running the IP base image always behaves
as if the connected and summary keywords were configured.
Related Documentation
These documents provide complete information about the Cisco Catalyst Blade Switch 3130 for Dell and
3032 for Dell and are available on Cisco.com:
3032 for Dell and are available on Cisco.com:
You can order printed copies of documents with a DOC-xxxxxx= number. For more information, see the