Cisco Cisco IOS Software Release 12.2(35)SE Notas de publicación

These are the updates to the Getting Started Guides for the Catalyst 3750-E and Catalyst 3560-E 
switches:

This information should be included in the “Install and Connect to Devices in the 10-Gigabit 
Ethernet Slots” section:

When you install or remove the converter module, the mode on the switch changes from 
10-Gigabit Ethernet to Gigabit Ethernet or the reverse. During this mode change, data traffic on 
the other switch uplink ports (X2 transceiver or SFP module ports) might temporarily stop. 

When you install or remove an X2 transceiver or SFP module, traffic delay does not occur.

This information should be included in the “Troubleshooting Express Setup” section:

POST errors are usually fatal. Contact your Cisco technical support representative if your 
switch fails POST.

These documents provide complete information about the Catalyst 3750-E and Catalyst 3560-E switches 
and are available on Cisco.com:

http://www.cisco.com/en/US/products/ps7077/tsd_products_support_series_home.html

http://www.cisco.com/en/US/products/ps7078/tsd_products_support_series_home.html

These documents provide complete information about the switches:

Catalyst 3750-E Switch Getting Started Guide 

Catalyst 3560-E Switch Getting Started Guide

Catalyst 3750-E and Catalyst 3560-E Switch Hardware Installation Guide 

Regulatory Compliance and Safety Information for the Catalyst 3750-E and Catalyst 3560-E Switch 

Catalyst 3750-E and Catalyst 3560-E Switch Software Configuration Guide 

Catalyst 3750-E and Catalyst 3560-E Switch Command Reference 

Cisco Software Activation and Compatibility Document 

Installation Notes for the Catalyst 3750-E and Catalyst 3560-E Switch Fan Module 

Installation Notes for the Cisco TwinGig Converter Module 

Device manager online help (available on the switch)