Cisco Cisco AnyConnect Secure Mobility Client v2.x Manual Técnica
Configure the ISE for Integration with an LDAP
Server
Server
Document ID: 119149
Contributed by Piotr Borowiec, Cisco TAC Engineer.
Jul 10, 2015
Jul 10, 2015
Contents
Introduction
Prerequisites
Requirements
Components Used
Background Information
Configure
Network Diagram
Configure OpenLDAP
Integrate OpenLDAP with the ISE
Configure the WLC
Configure EAP−GTC
Verify
Troubleshoot
Prerequisites
Requirements
Components Used
Background Information
Configure
Network Diagram
Configure OpenLDAP
Integrate OpenLDAP with the ISE
Configure the WLC
Configure EAP−GTC
Verify
Troubleshoot
Introduction
This document describes how to configure a Cisco Identity Services Engine (ISE) for integration with a Cisco
Lightweight Directory Access Protocol (LDAP) server.
Lightweight Directory Access Protocol (LDAP) server.
Note: This document is valid for setups that use LDAP as the external identity source for the ISE
authentication and authorization.
authentication and authorization.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information this document is based on these software and hardware versions:
Cisco ISE Version 1.3 with patch 2
•
Microsoft Windows Version 7 x64 with OpenLDAP installed
•
Cisco Wireless LAN Controller (WLC) Version 8.0.100.0
•
Cisco AnyConnect Version 3.1 for Microsoft Windows
•