Cisco Cisco ASA 5506H-X with FirePOWER Services Guía De Instalación

Cisco Firepower Threat Defense for the ASA 5508-X and ASA 5516-X Using Firepower Management Center Quick Start Guide

5. Power on the Firepower Threat Defense Device

Cable the following to a Layer 2 Ethernet switch:

GigabitEthernet 1/2 interface (inside)

Management 1/1 interface (for the Firepower Management Center)

A local management computer

You can connect inside and management on the same network because the management interface acts 

like a separate device that belongs only to the Firepower Management.

Connect the GigabitEthernet 1/1 (outside) interface to your ISP/WAN modem or other outside device. By 
default, the IP address is obtained using DHCP, but you can set a static address during initial configuration.

5. Power on the Firepower Threat Defense Device

Attach the power cable to the Firepower Threat Defense device and connect it to an electrical outlet. 

Press the Power button on the back of the Firepower Threat Defense device.

Check the Power LED on the front of the Firepower Threat Defense device; if it is solid green, the device is 
powered on.

Check the Status LED on the front of the Firepower Threat Defense device; after it is solid green, the system 
has passed power-on diagnostics.

1

2

3

4

5

6

7

8

s

L

outside, DHCP from Modem

Default is 192.168.45.45

Layer 2 Switch

WAN Modem

Management Computer

192.168.45.2

Internet

GigabitEthernet 1/2
inside, 192.168.45.1
(Management Gateway)

Firepower

Management Center

192.168.45.44