Cisco Cisco ASA 5585-X with FirePOWER SSP-20 Guía De Instalación

Cisco ASA 5585-X Quick Start Guide

3. Network Considerations for Multiple SSPs

 

Connect the power cables to the electrical outlets.

Power on the ASA. If you have redundant power supplies, you must power on both modules.

Check the Power LED on the front of the ASA; the AC ON indicator should be green, the FAN ON indicator 
should be green, and the OUT OK indicator should be off.

3. Network Considerations for Multiple SSPs

The ASA SSP resides in slot 0 (bottom). A second SSP (or network module) can be installed in slot 1 (top). When 
you install a non-ASA SSP in slot 1, all non-management interfaces belong to the ASA in slot 0, while the 
management interfaces belong to the module. If you install dual ASA SSPs, then they are completely independent 
systems.

See the following table for default configurations for the Management interfaces depending on which module is 
installed in slot 1. Note that the left-hand Management interface (when facing the back of the chassis) is not 
configured by default.

Power Supply Module (PS0)

 

Power Supply Module (PS1)

249822

100-240V
15.0/8.0.A
56/60Hz

100-240V
15.0/8.0.A
56/60Hz

ASA Management 0/0
Default IP: 192.168.1.1

Module Management 1/0