Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point Guía De Diseño

WGB_1#sh ip int brief

If a WGB client does not associate with the WGB, note these tips to troubleshoot the problem:

The native VLAN that is configured on the WGB needs to be the same VLAN on the switch to which 
the WGB is connected. The switch port connected to the WGB should be Trunk.

Verify the client configuration and ensure that the client configuration is correct.

Check the show bridge command output in the autonomous AP and confirm that the AP is reading 
the client MAC address in the right interface.

Confirm that the subinterfaces that correspond to specific VLANs and different subinterfaces are 
mapped to the bridge group.

WGB reads the switch port behind as a client in its MAC address table.

If required, clear the bridge entry using the clear bridge command (remember that this command 
will remove all the wired and wireless clients associated with the WGB and make them associated 
again).

Ensure that the WGB has not exceeded its 20-client limitation.

Cisco WCS now reports the reason for the most recent reboot on the general panel of the access point 
details page (Monitor > Access Points > AP Name). (See 

Interface

IP Address

OK?

Method

Status

Protocol

BVI1

209.165.200.225

YES

DHCP

up

up

Dot11Radio0

unassigned

YES

unset

admindown

down

Dot11Radio1

unassigned

YES

TFTP

up

up

Dot11Radio1.184

unassigned

YES

other

up

up

Dot11Radio1.185

unassigned

YES

unset

up

up

FastEthernet0

unassigned

YES

other

up

up

FastEthernet0.184

unassigned

YES

unset

up

up

FastEthernet0.185

unassigned

YES

unset

up

up

Virtual-Dot11Radio0

unassigned

YES

TFTP

up

up

Virtual-Dot11Radio0.184

unassigned

YES

unset

up

up

Virtual-Dot11Radio0.185

unassigned

YES

unset

up

up