Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point Guía De Diseño

Click Apply to commit your changes.

Click Save Configuration to save your changes.

To configure global mesh parameters including authentication methods using the controller CLI, follow 
these steps.

See the 

 for descriptions, 

valid ranges, and default values of the parameters used in the CLI commands.

To specify the maximum range (in feet) of all mesh access points in the network, enter this command:

config mesh range feet

To see the current range, enter show mesh range.

To enable or disable IDS reports for all traffic on the backhaul, enter this command:

config mesh ids-state {enable | disable}

To specify the rate (in Mbps) at which data is shared between access points on the backhaul interface, 
enter this command:

config ap bhrate {rate | auto} Cisco_AP 

To enable or disable client association on the primary backhaul (802.11a) of a mesh access point, enter 
these commands:

config mesh client-access {enable | disable}

config ap wlan {enable | disable} 802.11a Cisco_AP

config ap wlan {add | delete} 802.11a wlan_id Cisco_AP

To enable or disable VLAN transparent, enter this command:

config mesh ethernet-bridging VLAN-transparent {enable | disable}

To define a security mode for the mesh access point, enter one of the following commands:

To provide local authentication of the mesh access point by the controller, enter this command:

To store the MAC address filter in an external RADIUS server for authentication instead of the 
controller (local), enter these commands:

config mesh radius-server index enable

To provide external authentication on a RADIUS server and define a local MAC filter on the 
controller, enter these commands: