Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point Guía De Instalación

To configure DHCP Option 43 for Cisco 1000 and 1500 (1505 and 1510) series lightweight access 
points in the embedded Cisco IOS DHCP server, follow these steps:

Enter configuration mode at the Cisco IOS command line interface.

Create the DHCP pool, including the necessary parameters such as default router and name 
server as shown in the following example:

 IP Network Netmask

 Default router

 DNS Server

Where:

pool name is the name of the DHCP pool, such as AP1000.

IP Network is the network IP address where the controller resides, such as 

10.0.15.1

Netmask is the subnet mask, such as 255.255.255.0

Default router is the IP address of the default router, such as 10.0.0.1

DNS Server is the IP address of the DNS server, such as 10.0.10.2

Add the Option 60 line using the following syntax:

 “VCI string”

For the VCI string, use the value from Table 3. The quotation marks must be included.

Add the Option 43 line using the following syntax:

For example, if you are configuring Option 43 for Cisco 1000 or 1500 series access points 
using the controller IP addresses 10.126.126.2 and 10.127.127.2, add the following line to 
the DHCP pool in the Cisco IOS CLI. Be sure to include the quotation marks:

The quotation marks must be included.