Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point Guía De Instalación

Descargar
Página de 10
 
6
EU Directive 1999/5/EC - Compliance Information for the AIR-LAP1520 Series Lightweight IEEE802.11 a/b/g Outdoor Mesh Access Points
78-18485-02
  National Restrictions
The following sections identify countries having additional requirements or restrictions than those listed 
in 
France
For 2.4 GHz, the output power is restricted to 10 mW EIRP when the product is used outdoors in the 
band 2454 - 2483,5 MHz. There are no restrictions when used in other parts of the 2,4 GHz band. Check 
 for more details.
Pour la bande 2,4 GHz, la puissance est limitée à 10 mW en p.i.r.e. pour les équipements utilisés en 
extérieur dans la bande 2454 - 2483,5 MHz. Il n'y a pas de restrictions pour des utilisations dans d'autres 
parties de la bande 2,4 GHz. Consultez
 pour de plus amples détails.
Italy
This product meets the National Radio Interface and the requirements specified in the National 
Frequency Allocation Table for Italy. Unless this wireless LAN product is operating within the 
boundaries of the owner's property, its use requires a “general authorization.” Please check 
 for more details.
Questo prodotto è conforme alla specifiche di Interfaccia Radio Nazionali e rispetta il Piano Nazionale 
di ripartizione delle frequenze in Italia. Se non viene installato all 'interno del proprio fondo, l'utilizzo 
di prodotti Wireless LAN richiede una “Autorizzazione Generale”. Consultare 
 per maggiori dettagli.
Latvia
The outdoor usage of the 2.4 GHz band requires an authorization from the Electronic Communications 
Office. Please check 
for more details.
2,4 GHz frekven?u joslas izmantošanai ?rpus telp?m nepieciešama at?auja no Elektronisko sakaru 
direkcijas. Vair?k inform?cijas: 
Note
Although Norway, Switzerland and Liechtenstein are not EU member states, the EU Directive 
1999/5/EC has also been implemented in those countries.
Note
The regulatory limits for maximum output power are specified in EIRP. The EIRP level of a device can 
be calculated by adding the gain of the antenna used (specified in dBi) to the output power available at 
the connector (specified in dBm).