Cisco Cisco ASA 5540 Adaptive Security Appliance Manual Técnica

All other clients, including LAN−to−LAN connections, can connect to a security appliance on which load
balancing is enabled, but they cannot participate in load balancing.

The information in this document is based on these software and hardware versions:

VPN Client Software Releases 4.6 and later

• 

Cisco ASA Software Releases 7.0.1 and later

Note: Extends load balancing support to ASA 5510 and ASA models later than 5520 that have a
Security Plus license with the 8.0(2) version.

• 

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

This document uses this network setup:

Refer to the Cisco Technical Tips Conventions for more information on document conventions.

VPN virtual cluster IP address, User Datagram Protocol (UDP) port, and shared secret must be
identical on every device in the virtual cluster.

• 

All devices in the virtual cluster must be on the same outside and inside IP subnets.

• 

Ensure that the IP addresses are configured on the outside and inside interfaces and you are able to get to the
Internet from your ASA.

Note: Ensure that ISAKMP is enabled on both the inside and outside interface. Select Configuration >
Features > VPN > IKE > Global Parameters in order to verify this.