Cisco Cisco Aironet 1530i Outdoor Access Point Prospecto

Core switch port configuration for the Root AP

interface GigabitEthernet1/0/21
switchport trunk encapsulation dot1q
switchport trunk native vlan 1107
switchport trunk allowed vlan 12,1107
switchport mode trunk

Remote switch port configuration that is connected to the Lan port of the Slave Rap.

interface GigabitEthernet1/0/5
switchport trunk encapsulation dot1q
switchport trunk native vlan 1107
switchport trunk allowed vlan 12,1107
switchport mode trunk

I defined SVI's on the remote switch for both vlan's so that I could easily do pings to verify
connectivity.

You should be able to ping both directions for the defined vlan's. Clients on the remote switch
should get dhcp addresses if configured or static addresses.

On the remote switch you should see the mac addresses of the various nodes being learned on
the remote switch port.

Jeff_3750#2#show mac address int gi1/0/5

         Mac Address Table

-------------------------------------------

Vlan    Mac Address       Type        Ports

----    -----------       --------    -----

1107    3cce.73d9.52e0    DYNAMIC     Gi1/0/5

1107    78da.6e59.a6be    DYNAMIC     Gi1/0/5

1107    78da.6e59.a6d0    DYNAMIC     Gi1/0/5

1107    aca0.164b.b295    DYNAMIC     Gi1/0/5

1107    aca0.164b.b2c6    DYNAMIC     Gi1/0/5

1107    d0d0.fd2e.2a02    DYNAMIC     Gi1/0/5

1107    f40f.1bad.1820    DYNAMIC     Gi1/0/5

 12    aca0.164b.b2c9    DYNAMIC     Gi1/0/5