Cisco Cisco FirePOWER Appliance 8250 Notas de publicación
Version 5.2.0.1
Sourcefire 3D System Release Notes
29
Features Introduced in Previous Versions
•
In rare cases, the system may require up to 3 hours to complete an update
or uninstall to Version 5.2 of the Sourcefire 3D System on a 3D7110 or
3D7120 managed device. Do not interrupt the update; allow the
post-update reboot to finish completely. (124148)
•
If a device group contains an inactive managed device, you may be unable
to edit the device group. (124286)
•
You can not use IPv6 addresses to configure connections to Sourcefire User
Agents (Policies > Users). As a workaround, configure the connection using
the associated IPv4 addresses instead. (124377)
•
Sourcefire documentation does not reflect that when you reimage a device
from Version 4.10.x to Version 5.2, if the device has interfaces configured to
fail open they will revert to a non-bypass (fail closed) configuration at first
boot and remain closed until you configure bypass mode for them. (125957)
•
If you apply a VPN deployment on a stack, cluster, or clustered stack and
then unregister the stack, cluster, or clustered stack from its managing
Defense Center, the VPN deployment remains active on the stack, cluster,
or clustered stack when you register the appliances to another Defense
Center. Additionally, you cannot manage the VPN deployment from the new
Defense Center. As a workaround, remove the VPN deployment from the
stack, cluster, or clustered stack before unregistering it from the Defense
Center. (128816, 130728)
•
In some cases, the system experiences issues with user account
management if devices running Version 5.1.1.x are managed by a Defense
Center running Version 5.2.x.x. As a workaround, update your managed
devices to Version 5.2. (130024)
Features Introduced in Previous Versions
No new features were introduced in Version 5.2.0.1.Functionality described in
previous versions may be superseded by other new functionality or updated
through resolved issues.
5.2
The following new features and functionality were introduced in Version 5.2:
Advanced Malware Protection
Version 5.2 adds two new features to enhance the malware protection
capabilities of the Sourcefire 3D System: malware blocking and network file
trajectory.