Cisco Cisco Firepower Management Center 4000 Notas de publicación

Version 5.2.0.1

Sourcefire 3D System Release Notes

6

Updating Your Appliances

following sections.

You must reimage appliances running Version 4.10.x of the system 

to Version 5.2 before you install this update. For more information and reimage 

instructions, see the Version 5.2 Sourcefire 3D System Release Notes and the 

Sourcefire 3D System Installation Guide.

Sourcefire 3D System Version Requirements

To update to Version 5.2.0.1, an appliance must be running at least Version 5.2. If 

you are running an earlier version, you can obtain updates from the 

.

A Defense Center must be running at least Version 5.2 to update its managed 

devices to Version 5.2.0.1.
The closer your appliances’ current version to the release version (Version 

5.2.0.1), the less time the update takes. 

Operating System Requirements

You can host 64-bit Sourcefire virtual appliances on the following hosting 

environments:

VMware ESX/ESXi 4.1

VMware vSphere Hypervisor 5.0

VMware vSphere Hypervisor 5.1

For more information, see the Sourcefire 3D System Virtual Installation Guide.

Time and Disk Space Requirements

The following table provides disk space and time guidelines for the Version 

5.2.0.1 update. Note that when you update a managed device with the Defense 

Center, the Defense Center requires additional disk space on its 

/Volume

 

partition.

 

Time and Disk Space Requirements

Series 2 Defense Centers

0.09MB

1181.4MB 

n/a

hardware 

dependent

Series 3 Defense Centers

0.1MB

707.8MB

n/a

16 minutes 

virtual Defense Centers

0.1MB

707.8MB

n/a

hardware 

dependent