Cisco Cisco FirePOWER Appliance 7010 Guía De Instalación
Initial Device Setup
Firepower 7000 Series Getting Started Guide
18
To redirect console output using the shell, you run a script from the appliance’s shell. Note that while all Firepower
devices support LOM, 7000 Series devices do not support LOM and physical serial access at same time. However,
the console setting is the same regardless of which access method you want to use.
devices support LOM, 7000 Series devices do not support LOM and physical serial access at same time. However,
the console setting is the same regardless of which access method you want to use.
Using the Shell
You can use the shell to redirect the console output.
To redirect the console output using the shell:
1.
Using your keyboard/monitor or serial connection, log into the appliance’s shell using an account with
Administrator privileges. The password is the same as the password for the appliance’s web interface.
Administrator privileges. The password is the same as the password for the appliance’s web interface.
2.
Type
expert
to display the shell prompt.
The prompt for the appliance appears.
3.
At the prompt, set the console output by typing one of the following commands:
—
To access the appliance using the VGA port:
sudo /usr/local/sf/bin/configure_console.sh vga
—
To access the appliance using the physical serial port:
sudo /usr/local/sf/bin/configure_console.sh serial
—
To access the appliance using LOM via SOL:
sudo /usr/local/sf/bin/configure_console.sh sol
4.
To implement your changes, reboot the appliance by typing
sudo
reboot
.
The appliance reboots.
Using the Web Interface
You can also redirect console output through the web interface.
To redirect the console output using the web interface:
1.
Select
System > Configuration.
2.
Select
Console Configuration.
3.
Select a remote console access option:
—
Select
VGA
to use the appliance's VGA port. This is the default option.
—
Select
Physical Serial Port
to use the appliance's serial port, or to use LOM/SOL on a Firepower 7050 device.
—
The LOM settings appear.
—
Select
Lights-Out Management
to use LOM/SOL on a 7000 Series device (except the Firepower 7050).
On these devices, you cannot use SOL and a regular serial connection at the same time. LOM settings appear.
4.
To configure LOM via SOL, enter the appropriate settings:
—
DHCP Configuration
for the appliance (
DHCP
or
Static
).
—
IP Address
to be used for LOM. The LOM IP address must be different from the management interface IP
address of the appliance.
—
Netmask
for the appliance.