Cisco Cisco 2504 Wireless Controller Guía De Instalación

This guide is designed to help you install and minimally configure your Cisco 2504 Wireless Controller 
(2504 controller), which is part of the Cisco 2500 Series Wireless Controllers.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful interference 
to radio communications. However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on.

Try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help. (cfr reference 15.105)

Safety warnings appear throughout this guide in procedures that may harm you if performed incorrectly. 
A warning symbol precedes each warning statement. The warnings below are general warnings that are 
applicable to the entire guide. Translated versions of the safety warnings in this guide are provided in