Cisco Cisco 2106 Wireless LAN Controller Notas de publicación

Before upgrading your controller to software release 5.2.193.0 in a mesh network, you must comply with 
the following rules.

 outlines the upgrade compatibility of controller mesh and non-mesh releases and indicates the 

intermediate software releases required as part of the upgrade path.

You can upgrade from all mesh releases to controller software release 5.2.193.0 without any 
configuration file loss.

If you downgrade to a mesh release, you must then reconfigure the controller. Cisco 
recommends that you save the configuration from the mesh release before upgrading to 
release 5.2.193.0 for the first time. Then you can reapply the configuration if you need to 
downgrade.

You cannot downgrade from controller software release 5.2.193.0 to a mesh release (4.1.190.5, 
4.1.191.22M, or 4.1.192.xM) without losing your configuration settings.

Configuration files are in the binary state immediately after upgrade from a mesh release to 
controller software release 5.2.193.0. After reset, the XML configuration file is selected.

Do not edit XML files.

Any field with an invalid value is filtered out and set to default by the XML validation engine. 
Validation occurs during bootup.

If you upgrade the controller from software release 4.1.191.xM to 4.1.192.xM and then to software 
release 5.2.193.0, the controller might reboot without a crash file. To work around this problem, 
manually reset the controller without saving the configuration after you upgrade the controller to 
software release 5.2.193.0. Also, make sure to check the RRM configuration settings after the reset 
to verify that they are correct (CSCsv50357).