Cisco Cisco Email Security Appliance X1050 Guía Para Resolver Problemas
Content Security FAQ: How do you access the CLI
on a Content Security appliance?
on a Content Security appliance?
Document ID: 117914
Contributed by Chris Haag, Cisco TAC Engineer.
Jul 11, 2014
Jul 11, 2014
Contents
Introduction
Prerequisites
Requirements
Components Used
How do you access the CLI on a Content Security appliance?
Prerequisites
Requirements
Components Used
How do you access the CLI on a Content Security appliance?
Introduction
This document describes how to access the CLI through a Telnet or Secure Shell (SSH) client on a Cisco
Content Security appliance.
Content Security appliance.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Cisco Email Security Appliance (ESA)
•
Cisco Web Security Appliance (WSA)
•
Cisco Security Management Appliance (SMA)
•
AsyncOS
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco ESA AsyncOS, all Versions
•
Cisco WSA AsyncOS, all Versions
•
Cisco SMA Versions AsyncOS, all Versions
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Note: This document references software that is not maintained or supported by Cisco. The information is
provided as a courtesy for your convenience. For further assistance, please contact the software vendor.
provided as a courtesy for your convenience. For further assistance, please contact the software vendor.