Cisco Cisco 5760 Wireless LAN Controller Referencia técnica
wireless mobility group keepalive
To configure the mobility group parameter and keep alive its ping parameters, use the wireless mobility
group keepalive command. To remove a mobility group parameter, use the no form of the command.
group keepalive command. To remove a mobility group parameter, use the no form of the command.
wireless mobility group keepalive {count number | interval interval }
no wireless mobility group keepalive {count numbe r| interval interval }
Syntax Description
Number of times that a ping request is sent to a mobility group member before
the member is considered unreachable. The range is from 3 to 20. The default
is 3.
the member is considered unreachable. The range is from 3 to 20. The default
is 3.
count number
Interval of time between each ping request sent to a mobility group member.
The range is from 1 to 30 seconds. The default value is 10 seconds.
The range is from 1 to 30 seconds. The default value is 10 seconds.
interval interval
Command Default
3 seconds for count and 10 seconds for interval.
Command Modes
Global Configuration.
Command History
Modification
Release
This command was introduced.
Cisco IOS XE 3.2SE
Usage Guidelines
The default values for interval is ten seconds and the default for retries is set to three.
Examples
This example shows how to specify the amount of time between each ping request sent to a mobility group
member to 10 seconds:
member to 10 seconds:
Controller(config)# wireless mobility group keepalive count 10
Consolidated Platform Command Reference, Cisco IOS XE Release 3SE (Cisco WLC 5700 Series)
OL-29471-01
843
wireless mobility group keepalive