Cisco Cisco 5508 Wireless Controller Referencia técnica
20
Rogue Management in a Unified Wireless Network using v7.4
Step 4
From the CLI:
(Cisco Controller) >show rogue ap detailed 68:bc:0c:93:f4:70
Rogue BSSID...................................... 68:bc:0c:93:f4:70
Is Rogue on Wired Network........................ No
Classification................................... Unclassified
Manual Contained................................. No
State............................................ Alert
First Time Rogue was Reported.................... Mon Feb 4 02:24:44 2013
Last Time Rogue was Reported..................... Mon Feb 4 02:33:42 2013
Reported By
AP 1
MAC Address.............................. 64:d9:89:47:d9:90
Name..................................... AP3600_1
Radio Type............................... 802.11n5G
SSID..................................... msnjs2012
Channel.................................. 165
RSSI..................................... -41 dBm
SNR...................................... 51 dB
Encryption............................... Enabled
ShortPreamble............................ Not Supported
WPA Support.............................. Enabled
Last reported by this AP................. Mon Feb 4 02:33:42 2013
Configure Channel Scanning for Rogue Detection
For a local/FlexConnect mode/Monitor mode AP there is an option under RRM configuration which
allows the user to choose which channel is scanned for rogues. Depending on the config, the AP scans
all channel/country channel/DCA channel for rogues.
allows the user to choose which channel is scanned for rogues. Depending on the config, the AP scans
all channel/country channel/DCA channel for rogues.
To configure this from the GUI:
Step 1
Go to Wireless > 802.11a/n or 802.11b/g/n > RRM > General