Cisco Cisco 5508 Wireless Controller Referencia técnica
27
Rogue Management in a Unified Wireless Network using v7.4
Configure Rogue Management
Configure RLDP
To configure RLDP in the controller's GUI:
Step 1
Go to Security > Wireless Protection Policies > Rogue Policies > General.
•
MonitorModeAps – Allows only APs in monitor mode to participate in RLDP.
•
All APs – Local/FlexConnect/Monitor mode APs participate in the RLDP process.
•
Disabled – RLDP is not triggered automatically. However, the user can trigger RLDP manually for
a particular MAC address through the CLI.
a particular MAC address through the CLI.
Note
Monitor mode AP will get preference over local/FlexConnect AP for performing RLDP if both of them
are detecting a particular rogue above -85dbm RSSI.
are detecting a particular rogue above -85dbm RSSI.
Step 2
From the CLI:
(Cisco Controller) >config rogue ap rldp enable ?
alarm-only Enables RLDP and alarm if rogue is detected
auto-contain Enables RLDP, alarm and auto-contain if rogue is detected.
(Cisco Controller) >config rogue ap rldp enable alarm-only ?
monitor-ap-only Perform RLDP only on monitor AP
Note
RLDP scheduling and triggering manually is configurable only through Command prompt.