Cisco Cisco Email Security Appliance C650 Referencia técnica
435
Cisco IronPort AsyncOS 7.5 CLI Reference Guide
OL-23407-01
Chapter
Cluster Management: This command can be used in all three machine modes
(cluster, group, machine).
(cluster, group, machine).
Batch Command: This command does not support a batch format.
Example
In the following example, the
snmpconfig
command is used to enable SNMP on
the “PublicNet” interface on port 161. A passphrase for version 3 is entered and
then re-entered for confirmation. The system is configured to service version 1
and 2 requests, and the community string
then re-entered for confirmation. The system is configured to service version 1
and 2 requests, and the community string
public
is entered for GET requests from
those versions 1 and 2. The trap target of
snmp-monitor.example.com
is entered.
Finally, system location and contact information is entered.
Table 3-151
snmpconfig
mail3.example.com> snmpconfig
Current SNMP settings:
SNMP Disabled.
Choose the operation you want to perform:
- SETUP - Configure SNMP.
[]> setup
Do you want to enable SNMP? [N]> y
Please choose an IP interface for SNMP requests.
1. Data 1 (192.168.1.1/24: buttercup.run)
2. Data 2 (192.168.2.1/24: buttercup.run)