Cisco Cisco Email Security Appliance C160 Referencia técnica

In this example, a new configuration file is pasted directly at the command line. 
(Remember to type Control-D on a blank line to end the paste command.) Then, 
the system setup wizard is used to change the default hostname, IP address, and 
default gateway information. Finally, the changes are committed. 

mail3.example.com> loadconfig

1. Paste via CLI

2. Load from file

[1]> 1

Paste the configuration file now.

Press CTRL-D on a blank line when done.

[The configuration file is pasted until the end tag </config>. Control-D 

Values have been loaded.

Be sure to run "commit" to make these settings active.

mail3.example.com> systemsetup

mail3.example.com> commit