Cisco Cisco Email Security Appliance C650 Guía De Instalación
3-10
Cisco 170 Series Hardware Installation Guide
OL-28365-01
Chapter
Figure 3-4
Attaching the C170, M170, or S170 Appliance to the Rack
Connecting the Interface Cables and Verifying Connectivity
This section describes how to connect the cables to the Console, Auxiliary, and Management ports.
Warning
Only trained and qualified personnel should install, replace, or service this equipment
.
Statement 49
Caution
Read the safety warnings in the Safety and Compliance Guide for the Cisco Content Security Appliances
and follow proper safety procedures when performing any tasks in this document. See:
and follow proper safety procedures when performing any tasks in this document. See:
To connect cables to the ports, perform the following steps:
Step 1
Place the appliance on a flat, stable surface, or in a rack (if you are rack-mounting it).
Step 2
Before connecting a computer or terminal to the ports, determine the baud rate of the serial port. The baud
rate must match the default baud rate (9600 baud) of the Console port of the Cisco 170 series appliance. Set
up the terminal as follows: 9600 baud (default), 8 data bits, no parity, 1 stop bits, and Flow Control (FC)
= Hardware.
rate must match the default baud rate (9600 baud) of the Console port of the Cisco 170 series appliance. Set
up the terminal as follows: 9600 baud (default), 8 data bits, no parity, 1 stop bits, and Flow Control (FC)
= Hardware.
Step 3
Connect the cables to the ports.
a.
Management port—for use with the Cisco S170 Web Security Appliance (Cisco S170).
330
8
40
Cisco ASA 5545
Adapative Secur
ity Appliance
BOOT
ACTIVE
PS1
ACTIVE
PS1
PS0
ALARM
VPN
HD1
HD0
1
0
COLD AISLE
Front Bezel
HOT AISLE
AIR FLOW DIRECTION
Rear I/O