Cisco Cisco Email Security Appliance C190 Guía Del Usuario
3-11
Cisco AsyncOS 8.0.2 for Email User Guide
Chapter 3 Setup and Installation
Using the System Setup Wizard
Using the System Setup Wizard
You must use the System Setup Wizard for the initial setup in order to ensure a complete configuration.
Later, you can configure custom options not available in the System Setup Wizard.
Later, you can configure custom options not available in the System Setup Wizard.
You can run the System Setup Wizard using a browser or the command line interface (CLI). For more
information, see
information, see
or
Before you begin, complete the prerequisites at
.
Warning
If you are setting up a virtual Email Security appliance, you will have to use the
loadlicense
command to load your virtual appliance license before running the System Setup Wizard. See the
Cisco Virtual Security Appliance Installation Guide for more information.
Cisco Virtual Security Appliance Installation Guide for more information.
Warning
The System Setup Wizard will completely reconfigure your system. You should only use the System
Setup Wizard the very first time you install the appliance, or if you want to completely overwrite your
existing configuration.
Setup Wizard the very first time you install the appliance, or if you want to completely overwrite your
existing configuration.
DNS (Internet or Specify Own):
Interfaces
Data2 Port
IPv4 Address / Netmask:
IPv6 Address / Prefix:
Fully Qualified Hostname:
Accept Incoming Mail:
Domain
Destination
Relay Outgoing Mail:
System
Data1 Port
IPv4 Address / Netmask:
IPv6 Address / Prefix:
Fully Qualified Hostname:
Message Security
SenderBase Reputation Filtering:
Enable / Disable
Anti-Spam Scanning Engine
None / IronPort
McAfee Anti-Virus Scanning Engine
Enable / Disable
Sophos Anti-Virus Scanning Engine
Enable / Disable
Outbreak Filters
Enable / Disable
Table 3-3
System Setup Worksheet: 1 Listener for All Email Traffic (continued)