Cisco Cisco Email Security Appliance C170 Guía Del Usuario
2-5
Cisco AsyncOS 8.5.5 for Email Security User Guide
Chapter 2 Accessing the Appliance
Command Line Interface (CLI)
Figure 2-4
Active Sessions
Command Line Interface (CLI)
The Cisco AsyncOS Command Line Interface is an interactive interface designed to allow you to
configure and monitor the appliance. The commands are invoked by entering the command name with
or without any arguments. If you enter the command without arguments, the command prompts you for
the required information.
configure and monitor the appliance. The commands are invoked by entering the command name with
or without any arguments. If you enter the command without arguments, the command prompts you for
the required information.
The Command Line Interface is accessible via SSH or Telnet on IP interfaces that have been configured
with these services enabled, or via terminal emulation software on the serial port. By factory default,
SSH and Telnet are configured on the Management port. Use the
with these services enabled, or via terminal emulation software on the serial port. By factory default,
SSH and Telnet are configured on the Management port. Use the
interfaceconfig
command to disable
these services.
For more information about specific CLI commands, see the Cisco AsyncOS CLI Reference Guide.
Command Line Interface Conventions
This section describes the rules and conventions of the AsyncOS CLI.
Command Prompt
The top-level command prompt consists of the fully qualified hostname, followed by the greater than (
>
)
symbol, followed by a space. For example:
If the appliance has been configured as part of a cluster, the prompt in the CLI changes to indicate the
current mode. For example:
current mode. For example:
or
See
for more information.
When running commands, the CLI requires input from you. When the CLI is expecting input from you,
the command prompt shows the default input enclosed in square brackets (
the command prompt shows the default input enclosed in square brackets (
[]
) followed by the greater
than (
>
) symbol. When there is no default input, the command-prompt brackets are empty.
mail3.example.com>
(Cluster Americas) >
(Machine losangeles.example.com) >