Cisco Cisco Email Security Appliance C190 Guía Del Usuario
3-19
Cisco IronPort AsyncOS 7.6 for Email Configuration Guide
OL-25136-01
Chapter 3 Setup and Installation
This is the first SMTP Routes entry. The SMTP Routes table allows you to redirect all email for each
domain (also known as a Recipient Access Table (RAT) entry) you enter to a specific mail exchange
(MX) host. In typical installations, the SMTP Routes table defines the specific groupware (for example,
Microsoft Exchange) server or the “next hop” in the email delivery for your infrastructure.
domain (also known as a Recipient Access Table (RAT) entry) you enter to a specific mail exchange
(MX) host. In typical installations, the SMTP Routes table defines the specific groupware (for example,
Microsoft Exchange) server or the “next hop” in the email delivery for your infrastructure.
For example, you can define a route that specifies that mail accepted for the domain
example.com
and
all of its subdomains
.example.com
is routed the to the groupware server
exchange.example.com
.
You can enter multiple domains and destinations. Click Add Row to add another domain. Click the trash
can icon to remove a row.
can icon to remove a row.
Note
Configuring SMTP Routes in this step is optional. If no SMTP routes are defined, the system will use
DNS to lookup and determine the delivery host for the incoming mail received by the listener. (See
“Routing Email for Local Domains” in the Cisco IronPort AsyncOS for Email Advanced Configuration
Guide for more information.)
DNS to lookup and determine the delivery host for the incoming mail received by the listener. (See
“Routing Email for Local Domains” in the Cisco IronPort AsyncOS for Email Advanced Configuration
Guide for more information.)
You must add at least one domain to the Recipient Access Table. Enter a domain —
example.com
, for
example. To ensure that mail destined for any subdomain of
example.net
will match in the Recipient
Access Table, enter
.example.net
as well as the domain name. For more information, see
.
Relaying Mail (Optional)
When configuring your interfaces to relay mail, you define the systems allowed to relay email through
the appliance.
the appliance.
These are entries in the RELAYLIST of the Host Access Table for a listener. See
for more information.
Mark the check box for Relay Outgoing Mail to configure the interface to relay mail. Enter the hosts that
may relay mail through the appliance.
may relay mail through the appliance.
When you configure an interface to relay outbound mail, the System Setup Wizard turns on SSH for the
interface as long as no public listeners are configured to use the interface.
interface as long as no public listeners are configured to use the interface.
In the following example, two interfaces with IPv4 addresses are created:
•
192.168.42.42 remains configured on the Management interface.
•
192.168.1.1 is enabled on the Data 1 Ethernet interface. It is configured to accept mail for domains
ending in .example.com and an SMTP route is defined for exchange.example.com.
ending in .example.com and an SMTP route is defined for exchange.example.com.
•
192.168.2.1 is enabled on the Data 2 Ethernet interface. It is configured to relay mail from
exchange.example.com.
exchange.example.com.
Note
The following example pertains to X1050/1060/1070, C650/660/670, and C350/360/370 appliances. For
C150/160 appliances, the Data 2 interface is typically configured for both incoming and outgoing mail
while the Data 1 interface is used for appliance management (see
C150/160 appliances, the Data 2 interface is typically configured for both incoming and outgoing mail
while the Data 1 interface is used for appliance management (see
).