Cisco Cisco Email Security Appliance C370D Guía Del Usuario
3-47
Cisco IronPort AsyncOS 7.5 for Email Configuration Guide
OL-25136-01
Chapter 3 Setup and Installation
C10/100/150/160 Listener Example
Note
The following example of creating a listener applies to C10/100/150/160
customers only.
customers only.
In this example portion of the
systemsetup
command, a listener named
MailInterface is configured to run on the MailNet IP interface. Then, it is
configured to accept all email for the domain
configured to accept all email for the domain
example.com
. An initial SMTP route
to the mail exchange
exchange.example.com
is configured. Then, the same
listener is configured to relay all email for all hosts within the domain
example.com
. (Note the dot at the beginning of the entry:
.example.com
)
Rate limiting is enabled, and the maximum value of 450 recipients per hour from
a single host is specified for the public listener.
a single host is specified for the public listener.
Maximum Number Of Messages Per Connection: 10,000
Maximum Number Of Recipients Per Message: 100,000
Maximum Number Of Recipients Per Hour: Disabled
Use SenderBase for Flow Control: No
Virus Detection Enabled: Yes
Allow TLS Connections: No
Would you like to change the default host access policy? [N]> n
Listener OutboundMAil created.
Defaults have been set for a Private listener.
Use the listenerconfig->EDIT command to customize the listener.
*****