Cisco Cisco Email Security Appliance C650 Guía Del Usuario
3-71
Cisco IronPort AsyncOS 7.1 for Email Configuration Guide
OL-22158-02
Chapter 3 Setup and Installation
Proceeding to the Next Steps
After you successfully configure your appliance to work with your Active
Directory Wizard, or skip the process, the System Setup Next Steps page appears.
Directory Wizard, or skip the process, the System Setup Next Steps page appears.
Figure 3-14
System Setup is Complete
Click the links on the System Setup Next Steps page to proceed with the
configuration of your IronPort appliances.
configuration of your IronPort appliances.
Accessing the Command Line Interface (CLI)
Access to the CLI varies depending on the management connection method you
chose in
chose in
. The factory default username
and password are listed next. Initially, only the admin user account has access to
the CLI. You can add other users with differing levels of permission after you have
accessed the command line interface for the first time via the admin account. (For
information about adding users, see “Common Administrative Tasks” in the Cisco
IronPort AsyncOS for Email Daily Management Guide.) The System Setup
Wizard asks you to change the password for the admin account. The password for
the admin account can also be reset directly at any time using the password
command.
the CLI. You can add other users with differing levels of permission after you have
accessed the command line interface for the first time via the admin account. (For
information about adding users, see “Common Administrative Tasks” in the Cisco
IronPort AsyncOS for Email Daily Management Guide.) The System Setup
Wizard asks you to change the password for the admin account. The password for
the admin account can also be reset directly at any time using the password
command.
To connect via Ethernet: Start an SSH or Telnet session with the factory default
IP address 192.168.42.42. SSH is configured to use port 22. Telnet is configured
to use port 23. Enter the username and password below.
IP address 192.168.42.42. SSH is configured to use port 22. Telnet is configured
to use port 23. Enter the username and password below.
To connect via a Serial connection: Start a terminal session with the
communication port on your personal computer that the serial cable is connected
to. Use the settings for serial port outlined in
communication port on your personal computer that the serial cable is connected
to. Use the settings for serial port outlined in
. Enter the username and password below.