Cisco Cisco Email Security Appliance X1050 Guía Del Usuario
3-61
Cisco IronPort AsyncOS 7.1 for Email Configuration Guide
OL-22158-02
Chapter 3 Setup and Installation
Each interface can be configured to accept mail (incoming), relay email
(outgoing), or appliance management. During setup, you are limited to one of
each. Typically, you would use one interface for incoming, one for outgoing, and
one for appliance management. On the C10 and C100 appliances, you would
typically use one interface for both incoming and outgoing mail, and the other
interface for management.
(outgoing), or appliance management. During setup, you are limited to one of
each. Typically, you would use one interface for incoming, one for outgoing, and
one for appliance management. On the C10 and C100 appliances, you would
typically use one interface for both incoming and outgoing mail, and the other
interface for management.
You must configure one interface to receive email.
Assign and configure a logical IP address to one of the physical Ethernet
interfaces on the appliance. If you decide to use both the Data 1 Ethernet port and
the Data 2 Ethernet port, you need this information for both connections.
interfaces on the appliance. If you decide to use both the Data 1 Ethernet port and
the Data 2 Ethernet port, you need this information for both connections.
C60/600/650/660, C30/300/350/360, and X1000/1050/1060 customers:
IronPort recommends using one of the physical Ethernet ports to connect directly
to the Internet for the purposes of receiving inbound email through public
listeners, and using another physical Ethernet port to connect directly to your
internal network for the purposes of relaying outbound email through private
listeners.
IronPort recommends using one of the physical Ethernet ports to connect directly
to the Internet for the purposes of receiving inbound email through public
listeners, and using another physical Ethernet port to connect directly to your
internal network for the purposes of relaying outbound email through private
listeners.
C10/100/150/160 customers: Typically, the System Setup Wizard will configure
only one physical Ethernet port with one listener for both receiving inbound email
and relaying outbound email.
only one physical Ethernet port with one listener for both receiving inbound email
and relaying outbound email.
See
.
The following information is required:
•
The IP address assigned by your network administrator.
•
The netmask of the interface.
The netmask can be in standard dotted decimal form or hexadecimal form.
•
(optional) A fully-qualified hostname for the IP address
Note
IP addresses within the same subnet cannot be configured on separate physical
Ethernet interfaces. See
Ethernet interfaces. See
for
more detailed information on Network and IP Address configuration.
Accepting Mail
When configuring your interfaces to accept mail, you define:
•
the domain for which to accept mail