Cisco Cisco Email Security Appliance C650 Guía Del Usuario
3-33
User Guide for AsyncOS 9.8 for Cisco Email Security Appliances
Chapter 3 Setup and Installation
Using the System Setup Wizard
Note
Because the
systemsetup
command only configures one listener for both inbound and outbound mail for
C170 and C190 appliances, all outgoing mail will be calculated in the Mail Flow Monitor feature (which
is normally used for inbound messages). See
is normally used for inbound messages). See
Enable Anti-Spam
Your appliance ships with a 30-day evaluation key for the Anti-Spam software. During this portion of
the
the
systemsetup
command, you can choose to accept the license agreements and enable Anti-Spam
globally on the appliance.
Anti-Spam scanning will then be enabled on the incoming mail policy.
Note
If you do not accept the license agreement, Anti-Spam is not enabled on the appliance.
See
for all of the Anti-Spam configuration options available on the appliance.
Select a Default Anti-Spam Scanning Engine
If you have enabled more than one anti-spam scanning engine, you are prompted to select which engine
will be enabled for use on the default incoming mail policy.
will be enabled for use on the default incoming mail policy.
Enable the Spam Quarantine
If you choose to enable an anti-spam service, you can enable the incoming mail policy to send spam and
suspected spam messages to the local Spam Quarantine. Enabling the Spam Quarantine also enables the
end-user quarantine on the appliance. Only administrators can access the end-user quarantine until
end-user access is configured.
suspected spam messages to the local Spam Quarantine. Enabling the Spam Quarantine also enables the
end-user quarantine on the appliance. Only administrators can access the end-user quarantine until
end-user access is configured.
See
.
Use SenderBase for Flow Control: Yes
Spam Detection Enabled: Yes
Virus Detection Enabled: Yes
Allow TLS Connections: No
Would you like to change the default host access policy? [N]>
Listener MailInterface created.
Defaults have been set for a Public listener.
Use the listenerconfig->EDIT command to customize the listener.
*****