Cisco Cisco Email Security Appliance X1050 Guía Del Usuario
34-33
User Guide for AsyncOS 9.8 for Cisco Email Security Appliances
Chapter 34 System Administration
Alerts
Note
If you enabled AutoSupport during System Setup, the email address specified will receive alerts for all
severities and classes by default. You can change this configuration at any time.
severities and classes by default. You can change this configuration at any time.
Procedure
Step 1
Select System Administration > Alerts.
Step 2
Click Add Recipient.
Step 3
Enter the recipient’s email address. You can enter multiple addresses, separated by commas.
Step 4
(Optional) If you want to receive software release and critical support notification alerts from Cisco
Support, check the Release and Support Notifications checkbox.
Support, check the Release and Support Notifications checkbox.
Step 5
Select the alert types and severities that this recipient will receive.
Step 6
Submit and commit your changes.
Configuring Alert Settings
The following settings apply to all alerts.
Note
Use the
alertconfig
CLI command to define the number of alerts to save on the appliance to view later.
Procedure
Step 1
Click Edit Settings on the Alerts page.
Step 2
Enter a Header From: address to use when sending alerts, or select Automatically Generated
(“alert@<hostname>”).
(“alert@<hostname>”).
Step 3
Mark the checkbox if you want to specify the number of seconds to wait between sending duplicate
alerts. For more information, see
alerts. For more information, see
•
Specify the initial number of seconds to wait before sending a duplicate alert.
•
Specify the maximum number of seconds to wait before sending a duplicate alert.
Step 4
You can enable AutoSupport by checking the IronPort AutoSupport option. For more information about
AutoSupport, see
AutoSupport, see
.
•
If AutoSupport is enabled, the weekly AutoSupport report is sent to alert recipients set to receive
System alerts at the Information level. You can disable this via the checkbox.
System alerts at the Information level. You can disable this via the checkbox.
Step 5
Submit and commit your changes.
Alert Settings
Alert settings control the general behavior and configuration of alerts, including: