Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point Guía Para Resolver Problemas
9
Troubleshooting a Mesh Network
OL-14326-01
LWAPP Discovery Request Never Sent by Access Point
This section highlights conditions associated with unsuccessful LWAPP joins by the access point and no
receipt of a discovery request at the controller.
receipt of a discovery request at the controller.
To monitor the messages being exchanged between APs and the controller, enter the following command
and monitor (or capture) the information for at least 15 minutes.
and monitor (or capture) the information for at least 15 minutes.
(Cisco Controller) > debug lwapp events enable
•
The debug lwapp events enable display provides information to help troubleshoot all of the
possible problems listed in
possible problems listed in
.
•
If after monitoring the debug lwapp events enable display for 15 minutes and, neither the NO
DISCOVER RESPONSE nor the NO JOIN REQUEST event appears, enter the following CLI
commands on the controller if you see this:
DISCOVER RESPONSE nor the NO JOIN REQUEST event appears, enter the following CLI
commands on the controller if you see this:
spamMeshRadiusProcessResponse: AP Authorization Failure for <MAC Address>
–
Enter debug disable-all to turn off the debug lwapp events enable command
–
Enter config wlan mac filtering enable wlan-id to enable the MAC filter on the WLAN
Note
The MAC filter is enabled by default in release 4.1.181 and later.
–
Enter config macfilter add mac-addr wlan-id to add the access point’s MAC address to the
WLAN’s MAC filter
WLAN’s MAC filter