Cisco Cisco TelePresence MX700 Prospecto
Navigate to: Device > Phone > Phone Configuration (continued from the previous page).
Navigate to the
Product Specific Configuration Layout section.
Manual registration of the endpoint
Product specific configuration layout
Continued from the previous page...
Navigate to the Product Specific Configuration Layout section:
If registered to TMS (Cisco TelePresence Management Suite)
or CTSMAN (Cisco TelePresence Manager), configure the
product specific configuration layout as appropriate.
Default Call Protocol: This parameter sets the default call
protocol of the device. This device only supports SIP
when registering to Cisco Unified CM. Default value is
SIP.
Quality Improvement Server: Specify a host name
or IP address of a remote system to collect quality
improvement reports from the device. Default value is ““
(empty) and maximum length is 256 characters.
Multipoint Mode: Endpoints that do not have a bulit-in
MultiSite feature can use the ad hoc conference bridge
on Cisco Unified CM.
• Choose Use Endpoint to use the built-in MultiSite
feature.
NOTE:
Applies to endpoints having MultiSite
capability and having the option key installed.
• Choose Use Media Resource Group List to use
the Conference Bridge (media resources) feature
on Cisco Unified CM. This will enable the ad hoc
conferencing feature and applies to non-MultiSite
endpoints.
When done click
Save.
Cisco TelePresence Endpoints and Cisco Unified Communications Manager
Quick Reference Guide
D14996.06 Administering TC6.3 Endpoints on CUCM 9.1.2, OCTOBER 2013.
www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved.
17
Mandatory Optional
Contents
Introduction
CUCM configuration
Endpoint configuration
About passwords
Appendices
CUCM configuration